Eizo RADIFORCE RX220 User Manual download pdf (Page 15)

Chapter 2 Adjusting Screen

2-3. Color Adjustment

●

To select the display mode (CAL Switch)

CAL Switch allows you to select easily the adequate mode suitable for the monitor’s application.

CAL Switch mode

Mode Purpose

1-DICOM Available to display in DICOM mode.

2-Custom Available for the color settings according to your preference.

3-CAL Displays the screen adjusted by calibration software.

4-Text Suitable for displaying texts for word processing or spreadsheets.

The mode menu

appears.

Procedure

Press .

Mode menu appears at the lower left of the screen.

The mode among the list is highlighted in turn each time is pressed.

You can switch the current mode with or while the mode menu is being displayed.

→1-DICOM←→2-Custom←→3-CAL←→4-Text←

NOTE

The Adjustment menu and the Mode menu cannot be displayed at the same time.

You can disable a specic mode to be selected. For more information, refer to “3-1 Enabling/Disabling Mode

Selection” (page 21).

•

●

To perform advanced adjustments

The <Color> menu of the Adjustment menu allows you to set and save the independent color adjustment

for each mode.

Attention

Wait 30 minutes or more from monitor power on before starting the color adjustment.

(Allow the monitor to warm up for at least 30 minutes before making adjustments.)

Perform the range adjustment rst when adjusting color for analog input signals.

(Refer to “To adjust color gradation automatically” on page 14).

The same image may be seen in different colors on multiple monitors due to their monitor-specic characteristics.

Make ne color adjustment visually when matching colors on multiple monitors.

•

NOTE

The values shown in “%” or “K” are available only as reference.•

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 45 46

No comments

Eizo RADIFORCE RX220 User Manual Page 15