Eizo T57S User Manual download pdf (Page 32)

7 TROUBLESHOOTING

3) The image has a background

shadow.

4) The image is flickering.

• The signal cable might be damaged. Please contact

the dealer.

• The monitor may be located close to a device that is

generating a magnetic field. Such devices include

speakers (other than the EIZO optional i·Sound

speaker), electric motors, high-voltage cables, and

other monitors. It may be solved by switching off

or moving the interfering device, or by relocating

the monitor.

• If the volume level of the EIZO optional i·Sound

speaker is too high, it may, in some cases, cause a

slight vibration. To eliminate, turn down the

volume of the speaker.

• Try adjusting the convergence in the

ScreenManager’s Screen menu.

See page 10.

• This problem can occur when using BNC

connection and the termination switch is set

incorrectly. The termination switch should be set to

75 ohms for a connection to a single monitor.

See page 27.

• Flicker will occur with interlaced scanning, or

non-interlaced scanning with a low refresh rate. All

EIZO monitors are capable of reproducing high

refresh rates for non-interlaced scanning. If a

problem occurs when using a non-interlaced signal,

try adjusting the graphics board to increase the

refresh rate (if possible). Refer to the graphics

board manual for information.

• A unstable signal from the graphics board may be the cause of the above problem

when using the monitor with a high resolution or in a high refresh mode. (The video

signal from the graphics board might be made irregular due to the use of a high

speed dot clock.) Change the resolution or the refresh rate to another setting.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 47 48

No comments

Eizo T57S User Manual Page 32