Eizo RadiForce RX211 User Manual download pdf (Page 10)

Notice for this monitor

• This product is suited to display medical images of such modalities as MRI and CT. It does

not support the display of mammography images for diagnosis.

• This product has been adjusted speciﬁcally for use in the region to which it was originally

shipped. If the product is used outside the region, it may not operate as speciﬁed in the

speciﬁcations.

• This product may not be covered by warranty for uses other than those described in this

manual.

• The speciﬁcations noted in this manual are only applicable for power cords and signal cables

speciﬁed by us.

• Use optional products manufactured or speciﬁed by us with this product.

• As it takes about 30 minutes for the performance of electrical parts to stabilize, adjust the

monitor 30 minutes or more after the monitor power has been turned on.

• When the screen image is changed after displaying the same image for extended periods of

time, an afterimage may appear. Use the screen saver or timer to avoid displaying the same

image for extended periods of time.

• Periodic cleaning is recommended to keep the monitor looking new and to prolong its

operation lifetime. (Refer to "Cleaning" on the next page.)

• The screen may have defective pixels. These pixels may appear as slightly light or dark area

on the screen. This is due to the characteristics of the panel itself, and not the product.

• The backlight of the LCD panel has a ﬁxed life span. When the screen becomes dark or

begins to ﬂicker, please contact your dealer.

• Do not press on the panel or edge of the frame strongly, as this may result in the display

malfunction, such as the interference patterns, etc. If pressure is continually applied to the

LCD panel, it may deteriorate or damage your LCD panel. (If the pressure marks remain on

the LCD panel, leave the monitor with a white or black screen. The symptom may disappear.)

• Do not scratch or press on the panel with any sharp objects, such as a pencil or pen as this

may result in damage to the panel. Do not attempt to brush with tissues as this may scratch

the LCD panel.

• When the monitor is cold and brought into a room or the room temperature goes up quickly,

dew condensation may occur inside and outside the monitor. In that case, do not turn the

monitor on and wait until dew condensation disappears, otherwise it may cause some

damages to the monitor.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 52 53

No comments

Eizo RadiForce RX211 User Manual Page 10