Eizo RadiForce RX211 User Manual download pdf (Page 19)

2. Cable Connection and Screen Adjustment

2-3. Connecting Two PCs to the Monitor

Two PCs can be connected to the monitor through the Signal 1 and the Signal 2 on the

back of the monitor.

Selecting the Active Input

The Input Signal Selection Switch on the control panel can be used to select either Signal 1

or Signal 2 as the active input at any time. Every time the Switch is touched, the input

changes. When the signal is switched, the active signal type (Signal 1 or 2/ Analog or

Digital) appears at the top right corner of the screen.

The Priority Input Signal

This function is used to select which PC will have priority to control the monitor by

selecting <Input Priority> in the ScreenManager <Setup> menu (See p. 23 to use the

ScreenManager).

In the case of only one signal being present at either input, the monitor

automatically detects and displays that signal.

Priority Setting Performance

(DVI-D Connector)

The monitor gives preference to Signal 2 in the following cases.·

•

When the power of the monitor is turned ON

•

When the signal input to Signal 1 is changed even if active input

was Signal 2

(D-Sub mini 15 pin Connector)

The monitor gives preference to Signal 2 in the following cases.·

•

When the power of the monitor is turned ON

•

When the signal input to Signal 2 is changed even if active input

was Signal 1

Manual The monitor will not detect signals automatically in this mode.

Select the active input by pressing the Input Signal Selection

Switch on the monitor’s control panel.

Tips

• When the “1” or “2” is selected, the power saving mode of the monitor activates only if

both PCs are in power saving mode.

SIGNAL1

DVI-D

SIGNAL2

D-Sub mini 15

Input Signal Selection Switch

English

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 52 53

No comments

Eizo RadiForce RX211 User Manual Page 19